Mains PYQs
UPSC Mains Electrical Engineering paper 1 2017 questions
- For the circuit shown in Fig. 1(a), find the current through $5\,\Omega$ resistor by using Thevenin's theorem and verify the same by using superposition theorem.
[Figure] Fig. 1(a): nodes A, B, C, D; $5\,\Omega$ between A and B; E1 = 100 V with $20\,\Omega$; E2 = 40 V with $6\,\Omega$; E3 = 20 V between D and C with $10\,\Omega$; E4 = 20 V with $7\,\Omega$; E5 = 50 V; E6 = 30 V with $4\,\Omega$
- A continuous time signal $x(t)$ is shown in Fig. 1(b). Sketch and label each of the following signals :
(i) $x(t)\,u(2-t)$
(ii) $x(t)\,\delta\left(t-\frac{7}{2}\right)$
[Figure] Fig. 1(b): $x(t)$ rises linearly from 0 at $t=-2$ to 1 at $t=0$, is 1 from 0 to 2, then 2 from 2 to 4, and 0 elsewhere
- Show that for a distortionless transmission line, the attenuation constant $\alpha$ does not depend on frequency, whereas the phase constant $\beta$ depends linearly on it.
- For the circuit given in Fig. 1(d)-
(i) draw the input and output waveforms;
(ii) find the average value of the output voltage waveform.
Assume that the diode in the circuit is ideal.
[Figure] Fig. 1(d): source $v(s) = \sin\omega t$, $\omega = 2*50*\pi$; $660\,\Omega$ resistor to the non-inverting input of an op-amp with supplies +15 V and -15 V, output $V_o$; $1\,\mathrm{k\Omega}$ resistor and a diode in the feedback path; $2\,\mathrm{k\Omega}$ resistor
- A 15-hp, 220-V, 3-phase, 50-Hz, 6-pole, Y-connected induction motor has the following parameters per phase :
$r_1 = 0.128\,\Omega$, $r_2' = 0.0935\,\Omega$, $(x_1 + x_2') = 0.496\,\Omega$, $r_c = 183\,\Omega$, $x_\phi = 8\,\Omega$
The rotational losses are equal to the stator core losses (hysteresis and eddy-current). For a slip of 3%, find the line current and power factor.
- For the Boolean function
$F(W, X, Y, Z) = \Sigma(0, 2, 5, 6, 7, 8, 10, 13)$
(i) find all the prime implicants;
(ii) give minimal representation;
(iii) find minimal two-level realization using NAND gates only.
- (i) What is meant by an infinite transmission line? Also, explain the term 'electrical length' of a transmission line. In what units is it measured?
(ii) Determine the electrical length of a 20 m long transmission line operating at 1 MHz, if $u = 0.7c$ on the line. Take $c = 3\times10^8$ m/s.
- Discuss the properties of a probability density function. What additional features a normal distribution has?
- The following test data were taken on a 30-kVA, 2400/240 V, 50-Hz, single-phase transformer :
Open-circuit test : $V = 2400$ V, $I = 0.3$ A, $P = 230$ W
Short-circuit test : $V = 70$ V, $I = 18.8$ A, $P = 1050$ W
Determine the primary voltage, real and reactive power input, and efficiency, when a current of 12.5 A at 240 V is drawn from the low-voltage side by a load of 0.8 p.f. lagging.
- A three-phase uncontrolled diode rectifier supplies a constant load current of 10 A and its supply voltage is 400 V line-to-line. Determine the following performance measures :
(i) Average output voltage
(ii) Supply r.m.s. current
(iii) Supply fundamental r.m.s. current
(iv) Supply 3rd, 5th, 7th and 9th harmonic r.m.s. current
(v) Supply current displacement factor
(vi) Supply power factor
(vii) AC power (supply power)
(viii) DC power (load power)
- Consider the $R$-$L$-$C$ circuit shown in Fig. 3(c), wherein
$I_S = 10$ A, $R = 2\,\Omega$, $L = 1$ H, $C = 0.5\,\mu$F, $i_L(0^-) = 0$
Determine $v(0^+)$, $\frac{dv}{dt}(0^+)$ and $\frac{d^2v}{dt^2}(0^+)$ after the switch is closed.
[Figure] Fig. 3(c): current source $I_S$, switch closing at $t=0$, then $R$, $L$, $C$ in parallel with currents $i_R$, $i_L$, $i_C$ and voltage $v$
- Explain and differentiate between the single sideband (SSB) modulation and double sideband suppressed carrier (DSB-SC) modulation. Show the DSB-SC modulated waveform for any chosen baseband signal waveform and spectrum of the baseband and the DSB-SC modulated wave.
- Find the Laplace transform of the function $f(t) = u(\sin 2t)$.
- Find the average voltage at the point $V_o$ in the circuit given in Fig. 4(c) :
[Figure] Fig. 4(c): source $v(t) = 5\sin\omega t$, $\omega = 2*\pi*50$; $1\,\mathrm{k\Omega}$ input resistor to the inverting input of an op-amp with supplies +15 V and -15 V, output $V_o$; $1\,\mathrm{k\Omega}$ feedback resistor with a Zener diode, $V_Z = 2.5$ V, $V_{FZ} = 0$ V (forward voltage drop)
- Prove that $\bar{A}B + \bar{B}C + \bar{A}C = \bar{A}B + \bar{B}C$.
- An industrial consumer is operating a 1 kW induction motor at a lagging power factor of 0.8 and at a source voltage of 200 V r.m.s. In order to reduce expenditure on power consumption, he wishes to raise the power factor to 0.95 lagging by connecting a circuit element in parallel with the load. Indicate the type of the circuit element (inductive or capacitive) and find the value if the operating frequency is 50 Hz.
- (i) Explain the operation of Boost converter with voltage and current waveforms across the Boost inductor. Assume continuous conduction.
(ii) Derive its output voltage equation in terms of duty cycle and input voltage.
- An amplitude modulated signal, viewed on an oscilloscope, has a crest voltage of 44 V peak-to-peak. The bottom (or trough) point of the wave measures 6 V peak-to-peak. Find the modulation factor, percentage modulation and peak-to-peak unmodulated carrier voltage.
- Obtain $z$-parameters of a two-port network in terms of its $ABCD$ parameters.
- (i) Find the value of average current flow through the load resistor for the circuit given in Fig. 6(a).
(ii) Find the value of r.m.s. current drawn from the source.
[Figure] Fig. 6(a): source $v(t) = 320\sin\omega t$, $\omega = 2*\pi*50$, bridge rectifier with diodes $D_1$, $D_2$, $D_3$, $D_4$, load of $320\,\mathrm{k\Omega}$ in series with a 160 V battery
- Determine the transfer function and therefrom the impulse response of the causal linear time invariant system described by the difference equation
$$y[n] - \frac{1}{4}y[n-1] - \frac{3}{8}y[n-2] = -x[n] + 2x[n-1]$$
- (i) Draw the circuit diagram of Wien bridge oscillator using OP-AMP.
(ii) Find the value of $R$ to get a sustained oscillation of 1115 Hz. Assume that the value of the capacitor is $0.1\,\mu$F.
- The electric field and magnetic field in free space are given by
$$E = \frac{100}{\rho}\cos(2\times10^7 t + \beta z)\,\hat{a}_\phi\ \mathrm{V/m}$$
$$H = \frac{H_0}{\rho}\cos(2\times10^7 t + \beta z)\,\hat{a}_\rho\ \mathrm{A/m}$$
Express these fields in phasor form and determine the constants $H_0$ and $\beta$ such that these fields satisfy Maxwell's equations. The permeability and permittivity of the free space are $4\pi\times10^{-7}$ H/m and $8.854\times10^{-12}$ F/m respectively.
- Find the state transition diagram and realization using $J$-$K$ flip-flops to count Mod 7 in the following sequence :
000, 001, 011, 100, 101, 111
- A 230-V, 10-hp DC series motor draws a line current of 36 A, when delivering rated power at its rated speed of 1200 r.p.m. The armature circuit resistance is $0.2\,\Omega$ and the series field winding resistance is $0.1\,\Omega$. The magnetization curve may be considered linear.
(i) Find the speed of this motor when it draws a line current of 20 A.
(ii) What is the developed torque at the new condition?
- A 400-V, 3-phase balanced source is connected to an unbalanced $\Delta$-connected load of impedances $\bar{Z}_{ab} = 10\angle{+45^\circ}\,\Omega$, $\bar{Z}_{bc} = 10\angle 0^\circ\,\Omega$ and $\bar{Z}_{ca} = 10\angle{-45^\circ}\,\Omega$. Determine the line currents (in phasor form), total active (real) and reactive powers.
- (i) Draw the circuit diagram of a bandpass filter using OP-AMP. Its parameters are $f_L = 300$ Hz, $f_H = 2$ kHz and passband gain is 4.
(ii) Calculate the value of $Q$. Assume that the capacitor value is $0.01\,\mu$F.
- Differentiate between stationary and non-stationary random processes. Give the properties of the first- and second-order distribution function of stationary random processes.