Mains PYQs
UPSC Mains Civil Engineering paper 2 2023 questions
- What are the approximate limits of chemical (oxide) composition in hydraulic cement ? Also state the function of oxides in brief.
- (i) Explain with neat sketches, how Work Breakdown Structure can be defined with respect to Construction Project Management.
(ii) With an example, explain how the work breakdown structure can be classified.
- What do you understand by workability of concrete ? Write the procedure for any one measurement method available to check the workability of concrete.
- A 100 km length railway line is to be constructed for doubling the existing track. Calculate the quantity of track material required to construct the track. Consider the length of rail as 13 m, density of sleepers as $(n + 4)$ and width of sleeper as 250 mm.
- The Fore Bearing of side AB of regular hexagonal polygon ABCDEFA in whole circle bearing system is $120^\circ$. Find the Fore Bearings and Back Bearings of all the other sides. Also find the bearings of line BE and BF.
- For a project consisting of several activities, the allotted time and the dependencies of the activities are presented above.
(i) Prepare a network and mark critical path in it.
(ii) Calculate Float, Earliest start, Earliest finish, Latest start and Latest finish times.
| Activity | Duration (days) | Predecessor |
| --- | --- | --- |
| P | 5 | - |
| Q | 4 | - |
| R | 6 | Q |
| S | 5 | P |
| T | 7 | P |
| U | 4 | T, R |
- Trains of different speeds are to be run on a $2^\circ$ curve on a broad gauge. The average speed of trains to be run on the track is 80 kmph. Calculate the value of equilibrium cant. Also calculate the maximum permissible speed on the track allowing the maximum cant deficiency.
- (i) An aircraft flew at the altitude of 5000 m above the mean sea level. Two consecutive photographs were taken with the camera of focal length 300 mm on the flat ground having elevation of 2000 m above mean sea level. The longitudinal overlap is 65% and photograph print size is $300\,\mathrm{mm} \times 300\,\mathrm{mm}$. Calculate the scale of the photograph and distance between the two consecutive exposure stations. [5]
(ii) What is spectral reflectance curve ? Explain its significance in Remote Sensing. [10]
- (i) Explain any two traffic surveys carried out to decide the geometric design features of a road. [5]
(ii) The relationship between speed and density for a given section of road was found to be $v = 100 - 1.2\,k$, where $v$ is speed in kmph and $k$ is the density in vehicles per km. Calculate the speed and density in which maximum flow could occur. Also draw the speed-density, speed-flow and flow-density diagrams indicating critical values. [15]
- Starting from ground point A having elevation of 100.500 m, levels from points B to F were taken inside a tunnel. The points B to F were marked in the ceiling of the tunnel keeping the staff inverted. Above staff readings were observed during the survey.
| Staff at | A | B | C | D | E | F |
| --- | --- | --- | --- | --- | --- | --- |
| Back sight | 1.234 | 1.345 | 1.730 | 2.056 | 2.156 | - |
| Foresight | - | 1.782 | 1.830 | 2.000 | 2.340 | 2.780 |
Calculate the levels of all the points marked inside the tunnel. Also apply the regular checks for calculations.
- Explain in brief (with neat sketches), the Phenomenon of Bulking of Sand. How does bulking of sand affect the concrete mix ?
- A machine was purchased for ₹4,50,000 on 1st January 2001 and erection and installation work costed ₹80,000. The same machine is replaced by a new one on 31st December 2020. If the scrap value was estimated at ₹1,50,000
(i) What should be the rate of depreciation fund on 15th June 2010 ?
(ii) If after 12 years of running, some assemblies are replaced and the replacement cost is ₹1,50,000, what will be the new rate of depreciation ?
- What is dampness in a building ? What are the main causes of dampness and what are the remedies being suggested for making a building damp-proof ?
- A flexible pavement has been designed for two lane single carriageway of width 7 m with the following data :
(i) Commercial vehicle per day in each direction = 750 (as on 31.03.2018)
(ii) Date of completion of construction = 31.03.2020
(iii) Rate of traffic growth = 10% per annum
(iv) Design life = 10 years
(v) Vehicle damage factor = 2.0
(vi) Lane distribution factor (LDF) for 2-lane single carriageway road = 0.75
(vii) LDF of 4-lane dual carriageway road = 0.75 in each direction
Due to some issues, starting of construction got delayed and work started on 01.04.2023. In the meantime government has decided to develop the road as four lane dual carriageway. Considering the same design data as planned earlier, calculate the new design life of the project. Assume any additional data required for the design suitably.
- A 6-hour unit hydrograph has the following ordinates :
| Time (hr) | 0 | 6 | 12 | 18 | 24 | 30 | 36 | 42 | 48 | 54 | 60 |
| --- | --- | --- | --- | --- | --- | --- | --- | --- | --- | --- | --- |
| 6-hr UH ordinate ($\mathrm{m^3/s}$) | 0 | 200 | 550 | 750 | 650 | 550 | 400 | 270 | 150 | 50 | 0 |
If $\phi$ index is 0.3 cm/hr and base flow is $25\,\mathrm{m^3/s}$, determine the ordinates of resulting hydrograph of flow in the catchment due to the storm given below :
| Time from start of storm (hr) | 0 | 6 | 12 | 18 |
| --- | --- | --- | --- |
| Accumulated rainfall (cm) | 0 | 3 | 8 | 12 |
- The annual precipitation and evaporation from each of the sub-areas P, Q, R and S are given below for a catchment.
| Sub-area | Area ($\mathrm{km^2}$) | Annual Precipitation (mm) | Annual Evaporation (mm) |
| --- | --- | --- | --- |
| P | 15 | 1000 | 500 |
| Q | 5 | 800 | 400 |
| R | 10 | 900 | 440 |
| S | 18 | 1200 | 650 |
Calculate the following for catchment :
(i) Annual average precipitation
(ii) Annual average evaporation
(iii) Annual runoff coefficients for the sub-areas and for the total catchment taken as a whole assuming no change in the ground water storage on an annual basis.
- Route the above flood hydrograph through a river reach :
The value of $x$ and $K$ in the Muskingham equation have been identified as 0.25 and 8 hr. The initial outflow discharge from the reach is $10\,\mathrm{m^3/s}$.
| Time (hr) | 0 | 4 | 8 | 12 | 16 | 20 | 24 | 28 |
| --- | --- | --- | --- | --- | --- | --- | --- | --- |
| Inflow ($\mathrm{m^3/s}$) | 10 | 20 | 30 | 30 | 25 | 20 | 35 | 12 |
- Explain the significance of the following from the point of view of water quality criteria :
(i) Nitrites
(ii) Nitrates
(iii) E-coli
(iv) B.O.D.
(v) Dissolved oxygen
- In a continuous flow settling tank 4 m deep and 80 m long, calculate the flow velocity for effective removal of 0.03 mm particles at $25^\circ\mathrm{C}$. The specific gravity of the particles is 2.65 and kinematic viscosity ($\nu$) for water may be taken as $0.01\,\mathrm{cm^2/sec}$.
- (i) A 50 cm well in an unconfined aquifer of saturated thickness 45 m yields 600 lpm under a drawdown of 3 m at the pumping well. What will be the discharge under a drawdown of 6 m ? Consider the radius of influence as 500 m.
(ii) What will be the discharge in a 30 cm well under a drawdown of 3 m for the unconfined aquifer as mentioned in part (i).
- How does the peak hour demand affect the design of a water supply scheme ? Sketch the fluctuation in demand for typical Indian conditions.
- (i) The B.O.D. of a sewage incubated for one day at $25^\circ\mathrm{C}$ has been found to be 100 mg/l. What will be the 5 day, $20^\circ\mathrm{C}$ B.O.D. ? Assume $K_{20} = 0.12$ at $20^\circ\mathrm{C}$. Take temperature coefficient, $\phi = 1.056$.
(ii) Despite widespread use of B.O.D., it has some limitations. Mention all those limitations.
- Discuss the following operational difficulties encountered in the operation of Activated Sludge process :
(i) Rising Sludge or Floating Sludge
(ii) Sludge Bulking
What kind of impact these are having in the operation of Activated Sludge process ?
- Explain the following :
(i) Specific capacity of a well
(ii) Specific yield of an aquifer
(iii) Perched water table
(iv) Intrinsic permeability
(v) Bulk pore velocity
- (i) Define Delta, Duty and Base Period, and derive the relationship among them. [7]
(ii) Discuss the factors influencing the selection of site for a proposed dam. [8]
- (i) Design a trapezoidal concrete lined channel to carry a discharge of $300\,\mathrm{m^3/s}$ at a slope of 1 in 4000. The side slope of the channel may be taken as 1.5 : 1. The value of $n$ for the lining material may be taken as 0.0125. Assume the $B/D$ ratio as 5. [10]
(ii) Describe briefly different type of spillways used in dams and methods used for dissipating energy of water discharged from them. [10]
- Mention the sources and health effects on human being of the following elements with reference to Air pollution :
Lead, Cadmium, Nickel, Mercury, Carbon Monoxide
- (i) Discuss the factors that must be considered in evaluating potential sanitary landfill sites.
(ii) How does the occurrence of gases and leachate in sanitary landfill take place ? Explain with the help of chemical reactions taking place.