Mains PYQs
UPSC Mains Civil Engineering paper 2 2018 questions
- (i) What are artificial stones? Describe the process of preparing artificial marble. [5]
(ii) Enumerate the characteristics of good building stone. [5]
- Two cars are approaching from the opposite directions at 100 kmph and 70 kmph. Compute the minimum sight distance required to avoid head-on collision of the cars, if reaction time of 2.5 seconds, coefficient of friction of 0.7 and brake efficiency of 50% are assumed.
- (i) With the help of a neat sketch, explain the traversing method of Plane Table Survey. [5]
(ii) A line $AB$ on a topographical map at 1 : 50000 scale measures 12 cm. The same line on an aerial photograph taken from an aircraft of flying height 2.7 km measures 10 cm. Assuming the terrain to be flat, compute the focal length of the camera lens used for taking this photograph. [5]
- (i) List different types of gauges along with their width specifications. List the factors affecting the choice of a gauge. [5]
(ii) A 6 degree curve branches off from a 3 degree main curve in an opposite direction in the layout of a BG yard. If the speed of train on the branch-line is restricted to 35 kmph, determine the speed restriction on the main line. Assume permissible deficiency in cant as 75 mm. [5]
- What are the advantages of pointing? Discuss the commonly employed types of pointing.
- Explain the following :
(i) Bulking of sand
(ii) Fineness modulus
(iii) Water-cement ratio
(iv) Slump test
- Define kerbs in roads. Discuss the important factors which control the geometric design of a highway.
- What are the various distinct stages in any construction project? Differentiate between briefing stage and tendering stage.
- Define 'optimistic time estimate', 'pessimistic time estimate' and 'most likely time estimate'. Explain how beta distribution is suitable for PERT analysis.
- Levelling was done from $A$ to $B$ and continued to a benchmark (BM) of elevation 88.500 m. The readings obtained in metre are given below. Find the reduced level (RL) of $A$ and $B$, and apply checks :
| BS | IS | FS | RL | Remarks |
|---|---|---|---|---|
| 1.622 | | | | $A$ |
| 1.874 | | 0.354 | | |
| 2.032 | | 1.780 | | |
| | 2.362 | | | $B$ |
| 0.984 | | 1.122 | | |
| 1.906 | | 2.824 | | |
| | | 2.036 | 88.500 | BM |
- (i) Discuss typical pavement failures along with their causes. [10]
(ii) Describe the purpose of traffic signals. Explain various methods of coordination of traffic signals. [10]
- What are the governing factors in selection of suitable roof-covering materials? Discuss various types of pitched roof.
- A horizontal circular curve is provided with a radius of 325 m for aligning a highway. Determine the following geometric features :
(i) Superelevation
(ii) Extra widening of pavement
(iii) Length of transition curve
Given the following data :
Design speed = 70 kmph
Length of wheel base of the largest truck = 6 m
Pavement width = 10.5 m
- A traverse $ABCDEA$ was run and observations are given below. Find out the error of closure and compute the corrected latitude and departure :
| Side | Distance (m) | Azimuth |
|---|---|---|
| $AE$ | 350.10 | $152^\circ46'12''$ |
| $ED$ | 579.03 | $64^\circ50'54''$ |
| $DC$ | 368.28 | $01^\circ10'06''$ |
| $CB$ | 382.20 | $262^\circ08'48''$ |
| $BA$ | 401.58 | $231^\circ22'00''$ |
- The normal annual precipitations of 5 rain gauges $A$, $B$, $C$, $D$ and $E$ are 1250 mm, 1020 mm, 760 mm, 1130 mm and 1370 mm respectively. During a particular storm, the precipitations recorded by the stations $A$, $B$, $C$ and $E$ are 132 mm, 92 mm, 68 mm and 102 mm respectively. The instrument at station $D$ was inoperative during the storm. Estimate the rainfall at station $D$ during that storm.
- What are the conditions which favour the selection of embankment dam?
- What are the requirements for the success of an irrigation project?
- Design a rapid sand filter for 4 MLD of water with a rate of filtration of $5000\,\mathrm{L/m^2/hr}$.
- Design a septic tank for a small colony of 300 persons with an average wastewater flow of 120 litres per head per day.
- Distinguish between :
(i) Aquifer and Aquitard
(ii) Influent and Effluent streams
(iii) Unconfined aquifer and Leaky aquifer
(iv) Specific yield and Specific retention of aquifer
(v) Water table and Piezometric surface
- A rural watershed consists of-
$5\,\mathrm{km^2}$ of forest area with $C = 0.1$
$2\,\mathrm{km^2}$ of agricultural area with $C = 0.25$
$1\,\mathrm{km^2}$ of unpaved streets with $C = 0.30$
$0.75\,\mathrm{km^2}$ of green cover with $C = 0.35$
$1.25\,\mathrm{km^2}$ of residential area with $C = 0.40$
where $C$ = coefficient of runoff. Estimate the peak runoff rate for rainfall with a return period ($T$) of 25 years, if the intensity-duration-frequency relationship for the watershed is
$$i = \frac{150\,T^{1/3}}{(t+12)^{0.5}}$$
where
$i$ = rainfall intensity in mm/hr
$T$ = return period in year
$t$ = duration of rainfall in minutes
The watershed has a time of concentration of 50 minutes.
- A catchment experiences a 2-hour duration isolated storm and the peak of the flood hydrograph due to this storm was found to be $220\,\mathrm{m^3/s}$. The total depth of rainfall was 47 mm. Estimate the peak of the 2-hour unit hydrograph of this catchment, assuming a constant base flow of $15\,\mathrm{m^3/s}$ and an average infiltration rate of 2.5 mm/hr. If the area of the catchment is $445\,\mathrm{km^2}$, determine the base width of the 2-hour unit hydrograph assuming that the unit hydrograph is triangular in shape.
- An earthen canal is to be designed to irrigate an area of 18000 ha of wheat during Rabi season. The duty at the head of the canal is determined to be $500\,\mathrm{ha/m^3/s}$. Design a trapezoidal canal with a side slope of 1.5 H : 1 V. Permissible velocity = 0.9 m/s; B/D ratio = 6; Manning's $n = 0.020$.
- Discuss the mechanisms of coagulation.
- Design high-rate and low-rate trickling filters using the following data using empirical formula :
Wastewater flow = 5 MLD
BOD of wastewater = 300 mg/L
BOD removal in PST = 25%
Desired BOD of treated wastewater = 50 mg/L
Recirculation ratio = 1.4
BOD of recirculated wastewater may be neglected.
- Develop a relationship between the side of a square section of one sewer and the diameter of a circular section of another sewer when both are hydraulically equivalent.
- Write about the various sources of radioactivity in the environment and its effects on the environment.
- What are the different types of municipal solid wastes? Explain about each of them.