Mains PYQs
UPSC IFoS Mains Agri Engg paper 1 2019 questions
- Name different soil conservation regions of India with salient soil conservation problems in these regions.
- Explain different types of engineering measures of soil erosion control. Mention the design criteria of contour bund.
- Explain briefly the application of remote sensing in water resources studies.
- Explain the stability analysis of retention walls and dams.
- Design a parabolic shaped waterway to carry a flow of $3\,\mathrm{m^3/sec}$ down a slope of 4 percent. An excellent stand of dub grass is to be maintained in the waterway. Assume the necessary data required for calculation and draw a parabolic cross-section. The maximum flow velocity allowed is $2.5\,\mathrm{m/sec}$.
- What is universal soil loss equation? Explain in detail various parameters involved in the computation of soil loss using this equation.
- Explain the measures for controlling gully formation.
- Explain the types of computer-assisted operations in digital image interpretation and analysis.
- Calculate the height of contour bund to be constructed on a land slope of 5 percent. Assume the following :
(i) Rainfall excess for 24 hours duration is 80 cm
(ii) 15 m is horizontal interval
(iii) Depth of water flow over the weir is 30 cm
- Write about design factors and layout to install shelter belt against wind erosion.
- Explain different methods for measurement of soil losses from agricultural watersheds (use diagrams wherever required).
- Explain different types of spillways used in gully control. Compare the structural and design features of these spillways.
- Calculate the volume of excavation required to construct a dugout farm pond, if-
(i) average depth of the pond is $5.0\,\mathrm{m}$;
(ii) bottom width is $15.0\,\mathrm{m}$;
(iii) side slope to be used is 2:1;
(iv) bottom length is $25.0\,\mathrm{m}$.
- Write about the methods used for computation of earthwork. Also, write in brief about different machineries/equipments used for land grading.
- Write short notes on :
(i) Grassed waterway
(ii) Nalla bunding
(iii) Movement of soil particles in wind erosion
(iv) Vegetative measures for soil erosion control
(v) Rational method for estimating runoff
- Construct a hyetograph from the rainfall data provided in the table :
| Time (h) | Time interval (min) | Rainfall depth received in time interval (mm) |
|---|---|---|
| Rain started at 12 : 36 p.m. | | |
| 12 : 43 p.m. | 7 | 1.0 |
| 12 : 52 p.m. | 9 | 1.2 |
| 1 : 02 p.m. | 10 | 1.5 |
| 1 : 05 p.m. | 3 | 1.5 |
| 1 : 19 p.m. | 14 | 6.5 |
| 1 : 26 p.m. | 7 | 4.6 |
| 1 : 37 p.m. | 11 | 2.6 |
| 1 : 49 p.m. | 12 | 1.8 |
| 2 : 03 p.m. | 14 | 1.2 |
| Rain stopped at 2 : 03 p.m. | | |
- Compute the peak runoff rate of 15 years return period from a watershed area of 150 ha to design the field diversion. The sub-watersheds of 50 ha, 75 ha and 25 ha are kept under cultivation ($c=0.5$), forest cover ($c=0.3$) and grassland ($c=0.3$), respectively. The other details are as follows :
(i) The maximum length of watercourse = 2500 m
(ii) Relief = 50 m
(iii) Slope of watershed = 2.5%
(iv) Watershed soil is clay; values of $a$, $b$, $k$ and $n$ are 0.1483, 0.50, 7.176 and 0.9459, respectively
- Explain the components of canal network in a large irrigation project using diagram.
- Write short notes on (with sketches/diagrams, wherever required) :
(i) Cavity tube wells
(ii) Dug-cum-bore wells
(iii) Driven wells
(iv) Filter points
- What are the causes of waterlogging and soil salinity in an irrigated agriculture/agricultural field?
- For a particular soil, moisture at field capacity is 29% (w/w) and irrigation is to be applied at a moisture content of 19% (w/w). The apparent specific gravity is 1.30 and depth of the soil to be wetted is 1 m. Determine-
(i) hectare-cm of water per hectare of land;
(ii) time required to irrigate 10 hectares of land with a $0.10\,\mathrm{m^3/sec}$ stream, if the efficiency of irrigation application is 75%.
- A cylindrical silo of $2.5\,\mathrm{m}$ diameter and $20\,\mathrm{m}$ in height is filled with wheat. Calculate the load on the bottom only. The silo is made of steel with smooth walls. The characteristics of stored wheat are as follows :
(i) The minimum bulk density = $720\,\mathrm{kg/m^3}$
(ii) The maximum bulk density = $830\,\mathrm{kg/m^3}$
(iii) The minimum angle of internal friction = $25^\circ$
(iv) The maximum angle of internal friction = $30^\circ$
(v) The minimum angle of friction on smooth sheeting = $18^\circ$
- Explain in detail the direct and indirect methods of soil moisture measurement/determination.
- Write in brief about different types of centrifugal pumps based on various criteria.
- Explain irrigation efficiency and also explain its different types along with formulas to compute them.
- Calculate the cost of fencing a square farm of 25 ha fenced by barbed wire using cement concrete posts. Take the following values :
(i) Posts : ₹ 335 per post of cement
(ii) Corner posts : ₹ 500 per post
(iii) Cost of barbed wire is ₹ 1,000 per 100 m
(iv) Cost of earthwork @ ₹ 50 per pit
(v) Cost of cement concrete @ ₹ 100 per pit
(vi) Labour charges for fixing wire are ₹ 3,000
(vii) Cost of gate is ₹ 15,000
Assume the $1.80\,\mathrm{m}$ high angle iron posts spaced $3\,\mathrm{m}$ apart with 6 lines of barbed wires are used.
- What is curve number method? Write the steps involved in the curve number method.
- Give the details of different greenhouse construction materials and covering materials.
- The following data were obtained in determining the soil moisture content at successive depths in the root zone prior to applying irrigation water :
| Depth of sampling (cm) | Wt. of moist soil sample (gm) | Oven dry wt. of soil sample (gm) |
|---|---|---|
| 0-25 | 134.60 | 126.82 |
| 25-50 | 136.28 | 127.95 |
| 50-75 | 122.95 | 115.32 |
| 75-100 | 110.92 | 102.64 |
The bulk density of the soil in the root zone was 1.50 gm/cc. The available moisture-holding capacity of the soil was 17.8 cm/m depth. Determine-
(i) moisture content at different depths in the root zone;
(ii) moisture content in the root zone at the time of irrigation;
(iii) net depth of water to be applied to bring the moisture content to field capacity;
(iv) gross irrigation requirement at an estimated field irrigation efficiency of 70%.
- Write on the following :
(i) Vertical drainage
(ii) Hydroponic system for growing plant
(iii) Layout of tile drainage system
(iv) Different types of dairy barn in brief
(v) Well development
- Briefly explain various irrigation water measurement devices that can be installed in an irrigation channel. Use appropriate diagrams, wherever necessary.
- What are the steps involved in the design of sprinkler irrigation system? Provide the formula, wherever required.
- Explain different filtration systems used in drip irrigation.
- A pump lifts 95000 litres of water per hour against a total head of $20\,\mathrm{m}$. Compute the water hp. If the pump has an efficiency of 75%, what size of prime mover is required to operate the pump? If a direct drive electric motor having an efficiency of 85% is used to operate the pump, compute the cost of electrical energy in a month of 30 days. The pump is operated for 12 hours per day for 30 days. The cost of electrical energy is ₹ 5 per unit.